GF3CA-Floor standing fryer

Features:
● Automatic lifting at the end of fry cycle.
● Flame failure safety device
● Italian gas valve
● Hi temperature limiting safety feature
● High thermal efficiency (about 50%)
● Cast iron burner
● Burner tubes well positioned across the vat for easy cleaning
● Deep cold zone design reduces wasteful oil deterioration by trapping crumbs under the cooking area.
● Latch lock 1-1/4” (32 mm) ball-type drain valve: no more accidental scalding. Oil drain height: 439 mm
● Casters at the back and 6” adjustable bullet feet in the front
● High quality stainless steel construction, hygienic & easy to clean
● High grade stainless steel: SUS 304 for food contact safety
● Heavy gauge design: 1.5 mm table top and oil tank; other structural area from 1.2 mm to 2.0 mm.

Description

Advantages of Autolift mechanism:
◇ Consistency: It helps maintain consistent cooking times and results for different batches of food.
◇ Safety: It reduces the risk of burns and accidents for kitchen staff as there is less need for operators to reach into hot oil.
◇ Productivity: The automation allows kitchen staff to focus on other tasks while the fryer takes care of the cooking process.

Model No. of tank Programming channels Dimensions
(mm)
Gas power Capacity
(L)
Fry area
(mm)
Under Filter automatically lifted up
GF3CA single tank 12 393 x 872 x (917+560) 93,000 btu/h
(27 kW)
23 – 25 353 x 355 no Yes
GF3CF single tank 12 400 x 775 x (910+255) 93,000 btu/h
(27 kW)
23 – 25 353 x 355 Yes no

Gas inlet pressure:
● Natural Gas : 2.0 kPa
● LP Gas : 2.8 kPa
● Town Gas : 1.5 kPa

Accessories:
● 2 fryer baskets
● Crumb screen
● Drain clog clearance prod
● Drain oil extension pipe
Optional: Gas regulator

Gas inlet: DN20
Electrical:220 V, 50 Hz / 60 Hz, 100 W (for computer control
& autolift), 250 W (for filter)

From the blog

Our latest posts

  • Isolate Power & Gas Before Servicing Commercial Gas Equipment

    Isolating power and gas is the first, most important step before cleaning burners, opening a gas train, or touching any ignition components. Done right, it prevents unexpected ignition, fuel release, shock, and equipment damage. This post gives technicians a precise, repeatable procedure you can embed in your SOPs. What “Isolate Power/Gas” Means Why both? Many

    Read more

  • Gas Pressure 101: Static vs. Dynamic — Which Reading Actually Matters?

    Set by dynamic, confirm with static: use dynamic pressure under load for manifold and inlet specs, and use static only to ensure you’re below the max. A quick field procedure and cues help you commission gas equipment right the first time.

    Read more

  • Reducing exhaust to improve yellow or lazy flame

    Why reducing exhaust can help (in some cases) Think of the kitchen as an air-balance equation: Exhaust (out) – Make-Up Air (in) = Pressure deficit (ΔP). In short: you’re not “adding oxygen” by reducing exhaust — you’re removing excessive suction so the oxygen already being supplied can actually reach the burners without being whisked away

    Read more